#ifndef CONFIG_H
#define CONFIG_H

/*
 *
 * TL; DR; If you are using Arduino IDE, you have to configure this file.
 * See the first section.
 *
 * This file controls how the sketch work so this is where your should
 * start to adjust settings. If you are using Arduino-Makefile you can
 * set these values by editing the EXTRA_FLAGS Makefile variable.
 *
 * If you are using the Arduino IDE and want to set a configuration
 * value, change the lines that look like this:
 *
 * // #define FOO ...
 *
 * to
 *
 * #define FOO 1
 *
 */

/*
 *
 * Configuration Section
 *
 * If you are using the Arduino IDE, change stuff in this section. All
 * values are commented out, but some have default values
 *
 */

///////////////////////////////////////////////////////////////////////////////
// Board version
//
// You have to set this to match your board. The build will fail if
// you don't set it.
//
// Values:
//  1: prototype-a, the hand assembled PCB
//  2: prototype-b, the china produced PCB
//
// Default: not set, you have to set it
// #define SM_BOARD_VERSION ...

#define SM_BOARD_VERSION 1

///////////////////////////////////////////////////////////////////////////////
// Wait for serial before starting
//
// If enabled the code won't start until you open the serial port
// monitor or otherwise connect to the serial port.
//
// This is useful to have defined when using the device with the
// Arduino IDE, but when you want to use it with a plant you don't
// want this to be set.
//
// Values:
//   0: Do not wait
//   1: Wait
// Default: 1
// #define WAIT_FOR_SERIAL_BEFORE_STARING ...

///////////////////////////////////////////////////////////////////////////////
// Persistent configuration
//
// If enabled the settings for each sensor will be persisted in EEPROM
//
// Values:
//  0: disabled
//  1: enabled
// Default: 0
// #define PERSISTENT_CONFIGURATION_SUPPORT ...

///////////////////////////////////////////////////////////////////////////////
// Use low power mode
//
// If enabled the device will try to use as little power as possible.
//
// Not fully functional yet so it is disabled by default.
//
// Values:
//  0: disabled
//  1: enabled
// Default: 0
// #define USE_LOW_POWER_MODE ...

/*
 *
 * Default Values Section
 *
 * Do not touch stuff in this section, it only sets default values.
 *
 */

#ifndef WAIT_FOR_SERIAL_BEFORE_STARING
#define WAIT_FOR_SERIAL_BEFORE_STARING 1
#endif

#ifndef PERSISTENT_CONFIGURATION_SUPPORT
#define PERSISTENT_CONFIGURATION_SUPPORT 1
#endif

#ifndef SM_DEBUG
#define SM_DEBUG 1
#endif

#ifndef LOW_POWER
#define LOW_POWER 0
#endif

// Default to Serial port.
#ifndef DEBUG_SINK
#define DEBUG_SINK 2
#endif

#endif