/**
******************************************************************************
* @file usb_conf.h
* @author MCD Application Team
* @version V4.0.0
* @date 21-January-2013
* @brief USB configuration header
******************************************************************************
* @attention
*
*
© COPYRIGHT 2013 STMicroelectronics
*
* Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
* You may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.st.com/software_license_agreement_liberty_v2
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*
******************************************************************************
*/
/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef __USB_CONF_H
#define __USB_CONF_H
/*-------------------------------------------------------------*/
/* EP_NUM */
/* defines how many endpoints are used by the device */
/*-------------------------------------------------------------*/
#define EP_NUM (2)
/*-------------------------------------------------------------*/
/* -------------- Buffer Description Table -----------------*/
/*-------------------------------------------------------------*/
/* buffer table base address */
/* buffer table base address */
#define BTABLE_ADDRESS (0x00)
/* EP0 */
/* rx/tx buffer base address */
#define ENDP0_RXADDR (0x10)
#define ENDP0_TXADDR (0x50)
/* EP1 */
/* buffer base address */
#define ENDP1_BUF0Addr (0x90)
#define ENDP1_BUF1Addr (0xC0)
/*-------------------------------------------------------------*/
/* ------------------- ISTR events -------------------------*/
/*-------------------------------------------------------------*/
/* IMR_MSK */
/* mask defining which events has to be handled */
/* by the device application software */
#define IMR_MSK (CNTR_CTRM | CNTR_WKUPM | CNTR_SUSPM | CNTR_ERRM | CNTR_SOFM \
| CNTR_ESOFM | CNTR_RESETM )
/*#define CTR_CALLBACK*/
/*#define DOVR_CALLBACK*/
/*#define ERR_CALLBACK*/
/*#define WKUP_CALLBACK*/
/*#define SUSP_CALLBACK*/
/*#define RESET_CALLBACK*/
#define SOF_CALLBACK
/*#define ESOF_CALLBACK*/
/* CTR service routines */
/* associated to defined endpoints */
#define EP1_IN_Callback NOP_Process
#define EP2_IN_Callback NOP_Process
#define EP3_IN_Callback NOP_Process
#define EP4_IN_Callback NOP_Process
#define EP5_IN_Callback NOP_Process
#define EP6_IN_Callback NOP_Process
#define EP7_IN_Callback NOP_Process
/*#define EP1_OUT_Callback NOP_Process*/
#define EP2_OUT_Callback NOP_Process
#define EP3_OUT_Callback NOP_Process
#define EP4_OUT_Callback NOP_Process
#define EP5_OUT_Callback NOP_Process
#define EP6_OUT_Callback NOP_Process
#define EP7_OUT_Callback NOP_Process
#endif /* __USB_CONF_H */
/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/