diff options
Diffstat (limited to 'doc/openocd.texi')
| -rw-r--r-- | doc/openocd.texi | 8 |
1 files changed, 6 insertions, 2 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index 2767d787..0253dc0d 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -3540,7 +3540,7 @@ board by (re)installing working boot firmware. @section Flash Configuration Commands @cindex flash configuration -@deffn {Config Command} {flash bank} driver base size chip_width bus_width target [driver_options] +@deffn {Config Command} {flash bank} name driver base size chip_width bus_width target [driver_options] Configures a flash bank which provides persistent storage for addresses from @math{base} to @math{base + size - 1}. These banks will often be visible to GDB through the target's memory map. @@ -3548,6 +3548,8 @@ In some cases, configuring a flash bank will activate extra commands; see the driver-specific documentation. @itemize @bullet +@item @var{name} ... may be used to reference the flash bank +in other flash commands. @item @var{driver} ... identifies the controller driver associated with the flash bank being declared. This is usually @code{cfi} for external flash, or else @@ -4456,7 +4458,7 @@ NAND chips must be declared in configuration scripts, plus some additional configuration that's done after OpenOCD has initialized. -@deffn {Config Command} {nand device} controller target [configparams...] +@deffn {Config Command} {nand device} name controller target [configparams...] Declares a NAND device, which can be read and written to after it has been configured through @command{nand probe}. In OpenOCD, devices are single chips; this is unlike some @@ -4470,6 +4472,8 @@ initialization has completed. Use it in board specific configuration files, not interactively. @itemize @bullet +@item @var{name} ... may be used to reference the NAND bank +in other commands. @item @var{controller} ... identifies the controller driver associated with the NAND device being declared. @xref{NAND Driver List}. |