diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/openocd.texi | 28 |
1 files changed, 28 insertions, 0 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index d0c51428..0cb6b1d4 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -835,6 +835,13 @@ openocd -c "fast enable" -c "interface dummy" -f target/str710.cfg @subsection Target state handling @itemize @bullet +@item @b{reg} [@option{#}|@option{name}] [value] +@cindex reg +@*Access a single register by its number[@option{#}] or by its [@option{name}]. +No arguments: list all available registers for the current target. +Number or name argument: display a register +Number or name and value arguments: set register value + @item @b{poll} [@option{on}|@option{off}] @cindex poll @*Poll the target for its current state. If the target is in debug mode, architecture @@ -880,6 +887,10 @@ With no arguments a "reset run" is executed @*Immediately halt the target, and execute the reset script (works only with certain configurations) @end itemize + +@item @b{soft_reset_halt} +@cindex reset +@*Requesting target halt and executing a soft reset. @end itemize @subsection Memory access commands @@ -919,6 +930,23 @@ These commands allow accesses of a specific size to the memory system: This will first attempt comparison using a crc checksum, if this fails it will try a binary compare. @end itemize +@subsection Breakpoint commands +@cindex Breakpoint commands +@itemize @bullet +@item @b{bp} <@var{addr}> <@var{len}> [@var{hw}] +@cindex bp +@*set breakpoint <address> <length> [hw] +@item @b{rbp} <@var{addr}> +@cindex rbp +@*remove breakpoint <adress> +@item @b{wp} <@var{addr}> <@var{len}> <@var{r}|@var{w}|@var{a}> [@var{value}] [@var{mask}] +@cindex wp +@*set watchpoint <address> <length> <r/w/a> [value] [mask] +@item @b{rwp} <@var{addr}> +@cindex rwp +@*remove watchpoint <adress> +@end itemize + @subsection Flash commands @cindex Flash commands @itemize @bullet |