diff options
Diffstat (limited to 'tcl/board')
-rw-r--r-- | tcl/board/hitex_str9-comstick.cfg | 4 | ||||
-rw-r--r-- | tcl/board/lubbock.cfg | 4 | ||||
-rw-r--r-- | tcl/board/str910-eval.cfg | 4 |
3 files changed, 6 insertions, 6 deletions
diff --git a/tcl/board/hitex_str9-comstick.cfg b/tcl/board/hitex_str9-comstick.cfg index 4d1bb2e4..c85681b1 100644 --- a/tcl/board/hitex_str9-comstick.cfg +++ b/tcl/board/hitex_str9-comstick.cfg @@ -73,7 +73,7 @@ $_TARGETNAME configure -event reset-init { $_TARGETNAME configure -work-area-phys 0x50000000 -work-area-size 16384 -work-area-backup 0 #flash bank <driver> <base> <size> <chip_width> <bus_width> -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash0 flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0 -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash1 flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0 diff --git a/tcl/board/lubbock.cfg b/tcl/board/lubbock.cfg index 095c60aa..b58ad5ad 100644 --- a/tcl/board/lubbock.cfg +++ b/tcl/board/lubbock.cfg @@ -12,9 +12,9 @@ jtag_ntrst_delay 250 # CS0, CS1 -- two banks of CFI flash, 32 MBytes each # each bank is 32-bits wide, two 16-bit chips in parallel -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash0 flash bank $_FLASHNAME cfi 0x00000000 0x02000000 2 4 $_TARGETNAME -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash1 flash bank $_FLASHNAME cfi 0x04000000 0x02000000 2 4 $_TARGETNAME # CS2 low -- FPGA registers diff --git a/tcl/board/str910-eval.cfg b/tcl/board/str910-eval.cfg index a2772a84..9e3f8810 100644 --- a/tcl/board/str910-eval.cfg +++ b/tcl/board/str910-eval.cfg @@ -58,9 +58,9 @@ $_TARGETNAME configure -event reset-init { } #flash bank str9x <base> <size> 0 0 <target#> <variant> -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash0 flash bank $_FLASHNAME str9x 0x00000000 0x00080000 0 0 0 -set _FLASHNAME $_CHIPNAME.flash +set _FLASHNAME $_CHIPNAME.flash1 flash bank $_FLASHNAME str9x 0x00080000 0x00008000 0 0 0 # For more information about the configuration files, take a look at: |