| Commit message (Collapse) | Author | Age | Files | Lines |
|
|
|
|
|
|
|
|
|
|
| |
flash programming via flash write_image or gdb load would
produce a bogus error message that the flash chip was to
small.
The solution is to limit the current flash programming
run to the current chip.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
| |
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
| |
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
|
|
|
| |
SMI interface hides the real SPI bus between SPEAr and
external flash.
Added comments to highlight the SPI operation, to help a
future rework in SPI generic and SPEAr specific drivers.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
|
|
| |
Add support and documentation for STMicroelectronics
SPEAr Serial Memory Interface (SMI).
Code tested on SPEAr3xx only.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
|
|
| |
Add comments to assembly flash loader for STM32. Add tiny improvement in
size of the algorithm (40 vs 48 bytes) and tiny speed improvement (~1.5%,
as time is wasted on waiting for end of operation anyway).
Signed-off-by: Freddie Chopin <freddie_chopin@op.pl>
|
|
|
|
|
|
| |
only if we do not have enough ram do we continue.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
|
| |
add missing error handling.
Output warning when assuming maximum flash size in the
family when failing to read.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
catch problems earlier.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
delete lots of crud by handling this all in one spot.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
- add comment where to find the various loaders src files.
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
|
|
| |
Part of making the fileio API more robust.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
memory leaks and missing check on memory allocation.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
struct imageection => struct imagesection
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
sensible error must be reported at failure site
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
| |
error is now reported at failure site.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
| |
These warnings are for architectures that do not
support non-aligned word access.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
| |
for non_cfi cfi chips free() was invoked on rodata.
The mystery is why this bug has survived for so long.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
|
|
| |
sizeof() is a bit less scary than seing assumption
about size of type, no bug as such.
Use NULL instead of 0 for pointers. More obvious that
it is a pointer from code inspection.
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
|
| |
Someone called David Carne popped up on IRC and offered a fix (as he's not
on this list so can;t post here). I am just passing it on. (thanx David)
10:54 < davidc__> Basically; the Numonyx M29W160ET has an incorrect CFI PRI
block; it describes the erase blocks backwards
10:54 < davidc__> the linked patch has a fixup for that part [really trivial]:
|
|
|
|
|
|
| |
This speeds up programming for targets with more working area,
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
|
|
|
| |
The patch improves flash erase for STR9x in case of a full bank erase.
Then the chip erase command is used instead which improves speed significantly.
Also I think it might help if e.g. STR912 enters some state where flash banks are locked, and a chip erase command is the key for unlocking the flash.
|
|
|
|
|
|
|
|
| |
This flash driver works on more than just two chips.
(Though it does need work still, e.g. to protect more than 64K.
(On non-'3748-A0 chips where errata allow that.))
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
|
|
|
|
|
|
|
|
|
| |
For the above targets the exit_point is
optional when used with run_algorithm, so remove it.
This makes updating the algorithm less error prone.
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
|
|
|
|
| |
This adds a nand driver support for the nuc910 target.
Note that ECC is not currently supported by this driver, although
it is supported by the peripheral.
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
|
|
| |
The nand probe now outputs the manufacturer if found.
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
|
|
|
| |
STR9 is ARMv5 arch so use bkpt instruction rather than
waste a breakpoint.
Signed-off-by: Spencer Oliver <ntfreak@users.sourceforge.net>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
|
| |
Review allocation of error numbers in openocd
to avoid overlap.
Put brackets around negative numbers to avoid
issues during macro expansion.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
| |
Wait is declared in /usr/include/sys/wait.h
Signed-off-by: Edgar Grimberg <edgar.grimberg@zylin.com>
|
|
|
|
|
|
| |
Add "static" qualifier to private variable.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
| |
Add "static" qualifier to private function.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
| |
Add "static" qualifier to private functions.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
|
|
|
| |
Add "static" qualifier to private functions.
Move duplicated global declarations from "target/avrt.c"
and "nor/avrf.c" to "target/avrt.h".
Remove unused declarations form "nor/avrf.c".
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Helper ./src/helper/membuf.c is only used in at91sam3.c
1) Replace membuf with LOG_*
2) The original code in sam3_GetDetails() invalidates
all the buffered output of sam3_GetInfo(). The new
code skips sam3_GetInfo() if its output should not
be printed.
Signed-off-by: Antonio Borneo <borneo.antonio@gmail.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
|
|
|
|
|
|
| |
when the verify failed, it didn't return an error,
which breaks e.g. tcl scripts that rely on this for
exceptions to work.
Found by -Wshadow
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|
|
|
|
| |
Signed-off-by: Øyvind Harboe <oyvind.harboe@zylin.com>
|