From 74ae645623f328b54f570dbe14c3cffb6046d269 Mon Sep 17 00:00:00 2001 From: dbrownell Date: Sat, 19 Sep 2009 06:42:50 +0000 Subject: Minor tweaks to description of JTAG adapter/dongle issues. git-svn-id: svn://svn.berlios.de/openocd/trunk@2729 b42882b7-edfa-0310-969c-e2dbd0fdcd60 --- doc/openocd.texi | 16 ++++++++++++---- 1 file changed, 12 insertions(+), 4 deletions(-) (limited to 'doc') diff --git a/doc/openocd.texi b/doc/openocd.texi index 4db8698b..b944912c 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -250,12 +250,16 @@ and has a built in relay to power cycle targets remotely. @section Choosing a Dongle -There are three things you should keep in mind when choosing a dongle. +There are several things you should keep in mind when choosing a dongle. @enumerate -@item @b{Voltage} What voltage is your target? 1.8, 2.8, 3.3, or 5V? Does your dongle support it? -@item @b{Connection} Printer Ports - Does your computer have one? -@item @b{Connection} Is that long printer bit-bang cable practical? +@item @b{Voltage} What voltage is your target - 1.8, 2.8, 3.3, or 5V? +Does your dongle support it? You might need a level converter. +@item @b{Pinout} What pinout does your target board use? +Does your dongle support it? You may be able to use jumper +wires, or an "octopus" connector, to convert pinouts. +@item @b{Connection} Does your computer have the USB, printer, or +Ethernet port needed? @item @b{RTCK} Do you require RTCK? Also known as ``adaptive clocking'' @end enumerate @@ -356,6 +360,10 @@ The two well known ``JTAG Parallel Ports'' cables are the Xilnx DLC5 and the MacGraigor Wiggler. There are many clones and variations of these on the market. +Note that parallel ports are becoming much less common, so if you +have the choice you should probably avoid these adapters in favor +of USB-based ones. + @itemize @bullet @item @b{Wiggler} - There are many clones of this. -- cgit v1.2.3