From a1009509fb0fc187243435a0f38ef327e2aac147 Mon Sep 17 00:00:00 2001 From: Yegor Yefremov Date: Mon, 14 Dec 2009 16:29:31 -0800 Subject: Common target file for Stellaris chips Common target.cfg file for LM3S CPU family [dbrownell@users.sourceforge.net: rename, generalize more] Signed-off-by: Yegor Yefremov Signed-off-by: David Brownell --- tcl/target/stellaris.cfg | 49 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 49 insertions(+) create mode 100644 tcl/target/stellaris.cfg (limited to 'tcl') diff --git a/tcl/target/stellaris.cfg b/tcl/target/stellaris.cfg new file mode 100644 index 00000000..6fafac94 --- /dev/null +++ b/tcl/target/stellaris.cfg @@ -0,0 +1,49 @@ +# TI/Luminary Stellaris LM3S chip family + +if { [info exists CHIPNAME] } { + set _CHIPNAME $CHIPNAME +} else { + set _CHIPNAME lm3s +} + +# CPU TAP ID 0x1ba00477 for early Sandstorm parts +# CPU TAP ID 0x2ba00477 for later SandStorm parts, e.g. lm3s811 Rev C2 +# CPU TAP ID 0x3ba00477 for Cortex-M3 r1p2 (on Fury, DustDevil) +# CPU TAP ID 0x4ba00477 for Cortex-M3 r2p0 (on Tempest) +# ... we'll ignore the JTAG version field, rather than list every +# chip revision that turns up. +if { [info exists CPUTAPID ] } { + set _CPUTAPID $CPUTAPID +} else { + set _CPUTAPID 0x0ba00477 +} + +jtag newtap $_CHIPNAME cpu -irlen 4 -irmask 0xf \ + -expected-id $_CPUTAPID -ignore-version + +# The "lm3s" variant uses a software reset rather than SRST. +# This stops the debug registers from being cleared; it works +# around an erratum which should be fixed in later silicon. +set _TARGETNAME $_CHIPNAME.cpu +target create $_TARGETNAME cortex_m3 -chain-position $_CHIPNAME.cpu \ + -variant lm3s + +# 8K working area at base of ram, not backed up +# +# NOTE: you may need or want to reconfigure the work area; +# some parts have just 6K, and you may want to use other +# addresses (at end of mem not beginning) or back it up. +$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size 0x2000 + +# JTAG speed ... slow enough to work with a 12 MHz RC oscillator; +# LM3S parts don't support RTCK +# +# NOTE: this may be increased by a reset-init handler, after it +# configures and enables the PLL. Or you might need to decrease +# this, if you're using a slower clock. +jtag_khz 500 +$_TARGETNAME configure -event reset-start {jtag_khz 500} + +# flash configuration ... autodetects sizes, autoprobed +flash bank $_CHIPNAME.flash stellaris 0 0 0 0 $_TARGETNAME + -- cgit v1.2.3