diff options
Diffstat (limited to 'tcl/interface/luminary.cfg')
| -rw-r--r-- | tcl/interface/luminary.cfg | 26 |
1 files changed, 23 insertions, 3 deletions
diff --git a/tcl/interface/luminary.cfg b/tcl/interface/luminary.cfg index c86dbb6e..e94e5149 100644 --- a/tcl/interface/luminary.cfg +++ b/tcl/interface/luminary.cfg @@ -1,11 +1,31 @@ # -# Luminary Micro Stellaris LM3S811 Evaluation Kit +# Luminary Micro Stellaris Evaluation Kits # -# http://www.luminarymicro.com/products/stellaris_811_evaluation_kits.html +# http://www.luminarymicro.com/products/evaluation_kits.html +# +# There are a number of evaluation kits for Stellaris Cortex-M3 chips. +# Currently they all bundle FT2232 based debug support. When that is +# used (instead of an external adapter), use this config file in one +# of these two modes: +# +# - Eval board debug ... debug of the Stellaris chip via port A. +# +# - Other board debug ... same thing, but the board acts as a debug +# adapter for another board (using a standard ARM JTAG connector). +# The Stellaris chip stays in reset. +# +# Those support both JTAG and SWD. SWD is an ARM-only two-wire debug +# protocol; in 2009, OpenOCD does not support SWD. +# +# Port B of the FT2232 chip is normally used as a serial link to the +# Stellaris chip. On most boards (but not older LM3S811 eval boards), +# when SWD is used Port B may instead be used to read low-bandwidth +# "SWO trace" data, including so-called "printf style" output from +# firmware via the ITM module as well as profile data. # interface ft2232 ft2232_device_desc "Stellaris Evaluation Board" -ft2232_layout evb_lm3s811 +ft2232_layout luminary_icdi ft2232_vid_pid 0x0403 0xbcd9 |