From 548bb19aa28ca2eec4b8f1c06cbb4b0ace162db3 Mon Sep 17 00:00:00 2001 From: ntfreak Date: Wed, 14 May 2008 14:13:38 +0000 Subject: - added jlink support, based on Jürgen Stuber patch MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit git-svn-id: svn://svn.berlios.de/openocd/trunk@658 b42882b7-edfa-0310-969c-e2dbd0fdcd60 --- doc/openocd.texi | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'doc/openocd.texi') diff --git a/doc/openocd.texi b/doc/openocd.texi index 7f13f042..c9bbed7c 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -176,6 +176,8 @@ build properly.} @option{--enable-presto_libftdi} @item @option{--enable-presto_ftd2xx} +@item +@option{--enable-jlink} @end itemize If you want to access the parallel port using the PPDEV interface you have to specify @@ -259,7 +261,7 @@ Set to <@var{enable}> to cause OpenOCD to send the memory configuration to gdb w requested. gdb will then know when to set hardware breakpoints, and program flash using the gdb load command. @option{gdb_flash_program enable} will also need enabling for flash programming to work. -Default behaviour is <@var{disable}> +Default behaviour is <@var{enable}> @item @b{gdb_flash_program} <@var{enable|disable}> @cindex gdb_flash_program Set to <@var{enable}> to cause OpenOCD to program the flash memory when a @@ -312,6 +314,10 @@ usbprog is a freely programmable USB adapter. @item @b{gw16012} Gateworks GW16012 JTAG programmer. @end itemize +@itemize @minus +@item @b{jlink} +Segger jlink usb adapter +@end itemize @end itemize @itemize @bullet @@ -326,6 +332,7 @@ is optional, in which case the reset speed is used. @item wiggler: maximum speed / @var{number} @item ft2232: 6MHz / (@var{number}+1) @item amt jtagaccel: 8 / 2**@var{number} +@item jlink: maximum speed in kHz (0-12000), 0 will use RTCK @end itemize Note: Make sure the jtag clock is no more than @math{1/6th × CPU-Clock}. This is -- cgit v1.2.3