From 1ac220df71f5e5e016bd3f376c67eb5f3d712612 Mon Sep 17 00:00:00 2001 From: zwelch Date: Mon, 15 Jun 2009 23:54:09 +0000 Subject: David Brownell : Add another board ... OMAP2420 "H4" board. This won't be very widely used with OpenOCD, but with mainline support in both U-Boot and Linux it at least makes for a more complete set (and another testcase). This is incomplete support in several respects. The ARM11 support is not very deep yet; most registers aren't available, and the ETM can't be hooked up. Plus, there's no script for OMAP-specific stuff like setting up the SDRAM controller. Eventually the same NAND controller driver should work with OMAP2 and OMAP3. git-svn-id: svn://svn.berlios.de/openocd/trunk@2242 b42882b7-edfa-0310-969c-e2dbd0fdcd60 --- tcl/board/omap2420_h4.cfg | 14 ++++++++++++++ 1 file changed, 14 insertions(+) create mode 100644 tcl/board/omap2420_h4.cfg (limited to 'tcl/board') diff --git a/tcl/board/omap2420_h4.cfg b/tcl/board/omap2420_h4.cfg new file mode 100644 index 00000000..4a5daaf6 --- /dev/null +++ b/tcl/board/omap2420_h4.cfg @@ -0,0 +1,14 @@ +# OMAP2420 SDP board ("H4") + +source [find target/omap2420.cfg] + +# NOTE: this assumes you're *NOT* using a TI-14 connector. +reset_config trst_and_srst separate + +# Board configs can vary a *LOT* ... parts, jumpers, etc. +# This GP board boots from cs0 using NOR (2x32M), and also +# has 64M NAND on cs6. +flash bank cfi 0x04000000 0x02000000 2 2 $_TARGETNAME +flash bank cfi 0x06000000 0x02000000 2 2 $_TARGETNAME + +# vim:syntax tcl -- cgit v1.2.3