# NXP LPC2478 ARM7TDMI-S with 512kB Flash and 64kB Local On-Chip SRAM (98kB total), clocked with 4MHz internal RC oscillator

if { [info exists CHIPNAME] } {
	set  _CHIPNAME $CHIPNAME
} else {
	set  _CHIPNAME lpc2478
}

if { [info exists ENDIAN] } {
	set  _ENDIAN $ENDIAN
} else {
	set  _ENDIAN little
}

if { [info exists CPUTAPID ] } {
	set _CPUTAPID $CPUTAPID
} else {
	set _CPUTAPID 0x4f1f0f0f
}

#delays on reset lines
jtag_nsrst_delay 100
jtag_ntrst_delay 100

# LPC2000 -> SRST causes TRST
reset_config trst_and_srst srst_pulls_trst

jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME -variant arm7tdmi-s_r4

# LPC2478 has 64kB of SRAM on its main system bus (so-called Local On-Chip SRAM)
$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x40000000 -work-area-size 0x10000 -work-area-backup 0

$_TARGETNAME configure -event reset-init {
	# Force target into ARM state
	armv4_5 core_state arm
	# Do not remap 0x0000-0x0020 to anything but the Flash
	mwb 0xE01FC040 0x01
}

# LPC2378 has 512kB of FLASH, but upper 8kB are occupied by bootloader.
# After reset the chip uses its internal 4MHz RC oscillator.
# flash bank lpc2000 <base> <size> 0 0 <target#> <variant> <clock> [calc checksum]
flash bank lpc2000 0x0 0x7D000 0 0 $_TARGETNAME lpc2000_v2 12000 calc_checksum

# Try to use RCLK, if RCLK is not available use "normal" mode. 4MHz / 6 = 666kHz, so use 500.
jtag_rclk 500