1 files changed, 31 insertions, 37 deletions
diff --git a/config.h b/config.h
index 52e6751..7ab5ac8 100644
--- a/config.h
+++ b/config.h
@@ -2,33 +2,33 @@
 #define CONFIG_H
 
 /*
-
-TL; DR; If you are using Arduino IDE, you have to configure this file.
-See the first section.
-
-This file controls how the sketch work so this is where your should
-start to adjust settings. If you are using Arduino-Makefile you can
-set these values by editing the EXTRA_FLAGS Makefile variable.
-
-If you are using the Arduino IDE and want to set a configuration
-value, change the lines that look like this:
-
-// #define FOO ...
-
-to
-
-#define FOO 1
-
-*/
+ *
+ * TL; DR; If you are using Arduino IDE, you have to configure this file.
+ * See the first section.
+ *
+ * This file controls how the sketch work so this is where your should
+ * start to adjust settings. If you are using Arduino-Makefile you can
+ * set these values by editing the EXTRA_FLAGS Makefile variable.
+ *
+ * If you are using the Arduino IDE and want to set a configuration
+ * value, change the lines that look like this:
+ *
+ * // #define FOO ...
+ *
+ * to
+ *
+ * #define FOO 1
+ *
+ */
 
 /*
-
-Configuration Section
-
-If you are using the Arduino IDE, change stuff in this section. All
-values are commented out, but some have default values
-
-*/
+ *
+ * Configuration Section
+ *
+ * If you are using the Arduino IDE, change stuff in this section. All
+ * values are commented out, but some have default values
+ *
+ */
 
 ///////////////////////////////////////////////////////////////////////////////
 // Board version
@@ -85,15 +85,13 @@ values are commented out, but some have default values
 // Default: 0
 // #define USE_LOW_POWER_MODE ...
 
-#define USE_LOW_POWER_MODE 1
-
 /*
-
-Default Values Section
-
-Do not touch stuff in this section, it only sets default values.
-
-*/
+ *
+ * Default Values Section
+ *
+ * Do not touch stuff in this section, it only sets default values.
+ *
+ */
 
 #ifndef WAIT_FOR_SERIAL_BEFORE_STARING
 #define WAIT_FOR_SERIAL_BEFORE_STARING 1
@@ -111,8 +109,4 @@ Do not touch stuff in this section, it only sets default values.
 #define LOW_POWER 0
 #endif
 
-#ifndef ENABLE_DEBUG_LOG
-#define ENABLE_DEBUG_LOG 1
-#endif
-
 #endif