1 files changed, 86 insertions, 0 deletions
diff --git a/config.h b/config.h
new file mode 100644
index 0000000..e18a655
--- /dev/null
+++ b/config.h
@@ -0,0 +1,86 @@
+#ifndef CONFIG_H
+#define CONFIG_H
+
+/*
+
+TL; DR; If you are using Arduino IDE, you have to configure this file.
+See the first section.
+
+This file controls how the sketch work so this is where your should
+start to adjust settings. If you are using Arduino-Makefile you can
+set these values by editing the EXTRA_FLAGS Makefile variable.
+
+If you are using the Arduino IDE and want to set a configuration
+value, change the lines that look like this:
+
+// #define FOO ...
+
+to
+
+#define FOO 1
+
+*/
+
+/*
+
+Configuration Section
+
+If you are using the Arduino IDE, change stuff in this section. All
+values are commented out, but some have default values
+
+*/
+
+// You have to set this to match your board. The build will fail if
+// you don't set it.
+//
+// Values:
+//  1: prototype-a, the hand assembled PCB
+//  2: prototype-b, the china produced PCB
+//
+// Default: not set, you have to set it
+// #define SM_BOARD_VERSION ...
+
+// If enabled the code won't start until you open the serial port
+// monitor or otherwise connect to the serial port.
+//
+// This is useful to have defined when using the device with the
+// Arduino IDE, but when you want to use it with a plant you don't
+// want this to be set.
+//
+// Values:
+//   0: Do not wait
+//   1: Wait
+// Default: 1
+// #define WAIT_FOR_SERIAL_BEFORE_STARING ...
+
+// If enabled the sensor's name will be persisted in EEPROM
+//
+// Values:
+//  0: disabled
+//  1: enabled
+// Default: 0
+// #define PERSISTENT_CONFIGURATION_SUPPORT ...
+
+/*
+
+Default Values Section
+
+Do not touch stuff in this section, it only sets default values.
+
+*/
+
+#ifndef WAIT_FOR_SERIAL_BEFORE_STARING
+#define WAIT_FOR_SERIAL_BEFORE_STARING 1
+#endif
+
+#ifndef PERSISTENT_CONFIGURATION_SUPPORT
+// Default to off, the code is not fully functional yet
+#define PERSISTENT_CONFIGURATION_SUPPORT 0
+#endif
+
+#ifndef SM_DEBUG
+#define SM_DEBUG 1
+#endif
+
+#endif
+