1 files changed, 42 insertions, 42 deletions
diff --git a/src/target/target/mega128.cfg b/src/target/target/mega128.cfg
index 978726d8..964542c9 100644
--- a/src/target/target/mega128.cfg
+++ b/src/target/target/mega128.cfg
@@ -1,42 +1,42 @@
-# for avr
-
-   set  _CHIPNAME avr
-   set  _ENDIAN little
-
-# jtag speed
-jtag_khz 4500
-
-reset_config  srst_only
-jtag_nsrst_delay 100
-
-#jtag scan chain
-if { [info exists CPUTAPID ] } {
-   set _CPUTAPID $CPUTAPID
-} else {
-   set _CPUTAPID 0x8970203F
-}
-jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
-
-set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
-target create $_TARGETNAME avr -endian $_ENDIAN -chain-position $_TARGETNAME
-
-#$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x20000000 -work-area-size 16384 -work-area-backup 0
-
-flash bank avr 0 0 0 0 0
-
-#to use it, script will be like:
-#init
-#jtag_khz 4500
-#reset init
-#verify_ircapture disable
-#
-#halt
-#wait halt
-#poll
-#avr mass_erase 0
-#flash write_image E:/Versaloon/Software/CAMERAPROTOCOLAGENT.hex
-#reset run
-#shutdown
-#
-# For more information about the configuration files, take a look at:
-# openocd.texi
+# for avr
+
+   set  _CHIPNAME avr
+   set  _ENDIAN little
+
+# jtag speed
+jtag_khz 4500
+
+reset_config  srst_only
+jtag_nsrst_delay 100
+
+#jtag scan chain
+if { [info exists CPUTAPID ] } {
+   set _CPUTAPID $CPUTAPID
+} else {
+   set _CPUTAPID 0x8970203F
+}
+jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
+
+set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
+target create $_TARGETNAME avr -endian $_ENDIAN -chain-position $_TARGETNAME
+
+#$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x20000000 -work-area-size 16384 -work-area-backup 0
+
+flash bank avr 0 0 0 0 0
+
+#to use it, script will be like:
+#init
+#jtag_khz 4500
+#reset init
+#verify_ircapture disable
+#
+#halt
+#wait halt
+#poll
+#avr mass_erase 0
+#flash write_image E:/Versaloon/Software/CAMERAPROTOCOLAGENT.hex
+#reset run
+#shutdown
+#
+# For more information about the configuration files, take a look at:
+# openocd.texi