summaryrefslogtreecommitdiff
path: root/tcl
Commit message (Expand)AuthorAgeFilesLines
...
* DM36x: Set OSCDIV dividerThomas Koeller2010-08-121-0/+7
* DM36x: Disable unused SYSCLKsThomas Koeller2010-08-121-1/+20
* DM36x: Use enable bit for PLL pre-dividerThomas Koeller2010-08-121-1/+1
* tcl: remove silly ocd_ prefix to array2mem and mem2arrayØyvind Harboe2010-08-116-15/+15
* board: added at91cap7a stk w/sdram config scriptsØyvind Harboe2010-08-111-0/+165
* config scripts: remove useless reference to OpenOCD docsØyvind Harboe2010-08-1110-30/+0
* cfg: add omapl138 support and da850evm preliminary supportBen Gardiner2010-08-102-0/+76
* Luminary-icdi comment updateDavid Brownell2010-08-031-0/+4
* lpc1768: even if rclk "works", it isn't necessarily the correct clkØyvind Harboe2010-08-021-2/+6
* Support NGX Technologies product NGX ARM USB JTAGPeter Stuge2010-08-011-0/+6
* Remove srst_pulls_trst from LPC2148 targetPeter Stuge2010-08-011-1/+1
* lpc7168: make flash available upon reset initØyvind Harboe2010-07-301-0/+19
* cfg: add Amontec JTAGkey2p interface config (Issue #26)Spencer Oliver2010-07-191-0/+11
* flash: add nuc910 nand driverSpencer Oliver2010-07-191-0/+3
* cfg: update rsc-w910 scriptSpencer Oliver2010-07-191-1/+2
* lm3s811-ek uses generic stellaris target configDavid Brownell2010-07-172-32/+4
* cfg: add Avalue RSC-W910 configSpencer Oliver2010-07-132-0/+89
* at91sam3s* supportOlaf Lüke2010-06-254-36/+76
* am3517 evm: use physical write to memory while target is runningØyvind Harboe2010-06-221-3/+3
* board: add alpha am3517evm ti board config fileØyvind Harboe2010-06-221-0/+97
* DM36x: pll & clock setupThomas Koeller2010-06-151-0/+127
* arm1136 scriptsmichal smulski2010-06-151-1/+2
* cfg: add pic32 virtual banksSpencer Oliver2010-05-261-0/+7
* There are no variants of arm7tdmi targetFreddie Chopin2010-05-247-7/+7
* All LPC2xxx chips are little endian and that cannot be changed - update confi...Freddie Chopin2010-05-247-53/+8
* add correct CPUTAPID value for LPC2129Freddie Chopin2010-05-241-6/+2
* Update "flash bank" helper comments for LPC2xxx chipsFreddie Chopin2010-05-248-7/+8
* LPC23xx and LPC24xx after reset run on internal 4MHz RC oscillator, so "flash...Freddie Chopin2010-05-241-1/+1
* at91sam9260: use RCLKØyvind Harboe2010-05-211-19/+12
* cfg: update stm32 performance stick configSpencer Oliver2010-05-211-1/+8
* board: dm355evm.cfg SDTIMR0/1 minor naming fixJon Povey2010-05-211-1/+1
* reset: fix reset halt bugGary Carlson2010-05-191-23/+59
* at91rm9200 : reset_config should go to the board config fileMarc Pignat2010-05-182-2/+3
* scripts: update flash bank namesSpencer Oliver2010-05-139-18/+18
* zy1000.cfg: gdb connect will fail first time without gdb-attachØyvind Harboe2010-05-121-0/+5
* cfg: add stm32eval board configsSpencer Oliver2010-05-074-1/+29
* zy1000: it has a CFI chip, no need for the ecosflash driverØyvind Harboe2010-04-301-1/+2
* Add Voipac PXA270 module supportMarek Vasut2010-04-261-0/+12
* Add VPACLink interface definitionMarek Vasut2010-04-261-0/+10
* telo: update configuration scripts to matched master branchmichal smulski2010-04-244-65/+4
* TCL SCRIPTS: fix command nameAntonio Borneo2010-04-153-3/+3
* TCL scripts: update to current "flash bank" syntaxAntonio Borneo2010-03-2612-20/+24
* PARPORT: add PARPORTADDR tcl variableSpencer Oliver2010-03-163-3/+21
* PIC32: add Microchip Explorer16 cfgSpencer Oliver2010-03-163-8/+14
* rename jtag_nsrst_assert_width as adapter_nsrst_assert_widthDavid Brownell2010-03-152-2/+2
* rename jtag_nsrst_delay as adapter_nsrst_delayDavid Brownell2010-03-1551-54/+54
* rename jtag_khz as adapter_khzDavid Brownell2010-03-1542-69/+69
* PIC32MX: update cfg scriptSpencer Oliver2010-03-151-10/+23
* Add support for Bus Pirate as a JTAG adapter.Michal Demin2010-03-111-0/+26
* PIC32: add flash algorithm supportSpencer Oliver2010-03-101-4/+12
generated by cgit v1.2.3 (git 2.46.0) at 2024-12-27 01:06:17 +0000