Move TCL script files -- Step 2 of 2:

- Move src/tcl to tcl/.
- Update top Makefile.am to use new path name.


git-svn-id: svn://svn.berlios.de/openocd/trunk@1919 b42882b7-edfa-0310-969c-e2dbd0fdcd60

1 files changed, 41 insertions, 0 deletions

diff --git a/tcl/target/readme.txt b/tcl/target/readme.txt
new file mode 100644
index 00000000..ca23c64b
--- /dev/null
+++ b/tcl/target/readme.txt
@@ -0,0 +1,41 @@
+Prerequisites:
+The users of OpenOCD as well as computer programs interacting with OpenOCD are expecting that certain commands 
+do the same thing across all the targets.
+
+Rules to follow when writing scripts:
+
+1. The configuration script should be defined such as , for example, the following sequences are working:
+	reset
+	flash info <bank>
+and
+	reset 
+	flash erase_address <start> <len>
+and
+	reset init
+	load
+	
+In most cases this can be accomplished by specifying the default startup mode as reset_init (target command 
+in the configuration file).
+ 
+2. If the target is correctly configured, flash must be writable without any other helper commands. It is 
+assumed that all write-protect mechanisms should be disabled.
+
+3. The configuration scripts should be defined such as the binary that was written to flash verifies
+(turn off remapping, checksums, etc...) 
+
+flash write_image [file] <parameters>
+verify_image [file] <parameters>
+
+4. jtag_khz sets the maximum speed (or alternatively RCLK). If invoked
+multiple times only the last setting is used.
+
+interface/xxx.cfg files are always executed *before* target/xxx.cfg
+files, so any jtag_khz in interface/xxx.cfg will be overridden by
+target/xxx.cfg. jtag_khz in interface/xxx.cfg would then, effectively,
+set the default JTAG speed.
+
+Note that a target/xxx.cfg file can invoke another target/yyy.cfg file,
+so one can create target subtype configurations where e.g. only
+amount of DRAM, oscillator speeds differ and having a single
+config file for the default/common settings.
+