diff options
Diffstat (limited to 'doc/openocd.texi')
| -rw-r--r-- | doc/openocd.texi | 17 |
1 files changed, 7 insertions, 10 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index 4a40551e..78d53c58 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -2509,22 +2509,19 @@ Use the standard str9 driver for programming. @xref{STR9 specific commands}. @subsection mFlash Configuration @cindex mFlash Configuration -@b{mflash bank} <@var{soc}> <@var{base}> <@var{chip_width}> <@var{bus_width}> -<@var{RST pin}> <@var{WP pin}> <@var{DPD pin}> <@var{target}> +@b{mflash bank} <@var{soc}> <@var{base}> <@var{RST pin}> <@var{target}> @cindex mflash bank @*Configures a mflash for <@var{soc}> host bank at -<@var{base}>. <@var{chip_width}> and <@var{bus_width}> are bytes -order. Pin number format is dependent on host GPIO calling convention. -If WP or DPD pin was not used, write -1. Currently, mflash bank -support s3c2440 and pxa270. +<@var{base}>. Pin number format is dependent on host GPIO calling convention. +Currently, mflash bank support s3c2440 and pxa270. -(ex. of s3c2440) mflash <@var{RST pin}> is GPIO B1, <@var{WP pin}> and <@var{DPD pin}> are not used. +(ex. of s3c2440) mflash <@var{RST pin}> is GPIO B1. @example -mflash bank s3c2440 0x10000000 2 2 1b -1 -1 0 +mflash bank s3c2440 0x10000000 1b 0 @end example -(ex. of pxa270) mflash <@var{RST pin}> is GPIO 43, <@var{DPD pin}> is not used and <@var{DPD pin}> is GPIO 51. +(ex. of pxa270) mflash <@var{RST pin}> is GPIO 43. @example -mflash bank pxa270 0x08000000 2 2 43 -1 51 0 +mflash bank pxa270 0x08000000 43 0 @end example @section Microcontroller specific Flash Commands |