diff options
Diffstat (limited to 'doc/openocd.texi')
| -rw-r--r-- | doc/openocd.texi | 16 |
1 files changed, 1 insertions, 15 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index 8f9ca93e..04605f09 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -540,11 +540,6 @@ Event is one of the following: @option{pre_resume} or @option{gdb_program_config}. @option{post_reset} and @option{reset} will produce the same results. -@item @b{run_and_halt_time} <@var{target#}> <@var{time_in_ms}> -@cindex run_and_halt_time -The amount of time the debugger should wait after releasing reset before it asserts -a debug request. This is used by the @option{run_and_halt} and @option{run_and_init} -reset modes. @item @b{working_area} <@var{target#}> <@var{address}> <@var{size}> <@var{backup}|@var{nobackup}> @cindex working_area @@ -795,8 +790,7 @@ OpenOCD will wait 5 seconds for the target to resume. @cindex step Single-step the target at its current code position, or at an optional address. -@item @b{reset} [@option{run}|@option{halt}|@option{init}|@option{run_and_halt} -|@option{run_and_init}] +@item @b{reset} [@option{run}|@option{halt}|@option{init}] @cindex reset Perform a hard-reset. The optional parameter specifies what should happen after the reset. @@ -812,15 +806,7 @@ Immediately halt the target (works only with certain configurations). @cindex reset init Immediately halt the target, and execute the reset script (works only with certain configurations) -@item @b{run_and_halt} -@cindex reset run_and_halt -Let the target run for a certain amount of time, then request a halt. -@item @b{run_and_init} -@cindex reset run_and_init -Let the target run for a certain amount of time, then request a halt. Execute the -reset script once the target enters debug mode. @end itemize -The runtime can be set using the @option{run_and_halt_time} command. @end itemize @subsection Memory access commands |