summaryrefslogtreecommitdiff
path: root/doc
diff options
context:
space:
mode:
Diffstat (limited to 'doc')
-rw-r--r--doc/openocd.texi19
1 files changed, 16 insertions, 3 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi
index dfb2f666..15144d02 100644
--- a/doc/openocd.texi
+++ b/doc/openocd.texi
@@ -273,12 +273,18 @@ Cirrus Logic EP93xx based single-board computer bit-banging (in development)
@end itemize
@itemize @bullet
-@item @b{jtag_speed} <@var{number}>
+@item @b{jtag_speed} <@var{reset speed}> <@var{post reset speed}>
@cindex jtag_speed
Limit the maximum speed of the JTAG interface. Usually, a value of zero means maximum
-speed. The actual effect of this option depends on the JTAG interface used.
-
+speed. The actual effect of this option depends on the JTAG interface used. Reset
+speed is used during reset and post reset speed after reset. post reset speed
+is optional, in which case the reset speed is used.
@itemize @minus
+
+
+
+
+
@item wiggler: maximum speed / @var{number}
@item ft2232: 6MHz / (@var{number}+1)
@item amt jtagaccel: 8 / 2**@var{number}
@@ -287,6 +293,13 @@ speed. The actual effect of this option depends on the JTAG interface used.
Note: Make sure the jtag clock is no more than @math{1/6th × CPU-Clock}. This is
especially true for synthesized cores (-S).
+@item @b{jtag_khz} <@var{reset speed kHz}> <@var{post reset speed kHz}>
+@cindex jtag_khz
+Same as jtag_speed, except that the speed is specified in maximum kHz. If
+the device can not support the rate asked for, or can not translate from
+kHz to jtag_speed, then an error is returned. 0 means RTCK. If RTCK
+is not supported, then an error is reported.
+
@item @b{reset_config} <@var{signals}> [@var{combination}] [@var{trst_type}] [@var{srst_type}]
@cindex reset_config
The configuration of the reset signals available on the JTAG interface AND the target.