diff options
Diffstat (limited to 'doc')
| -rw-r--r-- | doc/openocd.texi | 15 |
1 files changed, 7 insertions, 8 deletions
diff --git a/doc/openocd.texi b/doc/openocd.texi index 63ab6fed..dea01969 100644 --- a/doc/openocd.texi +++ b/doc/openocd.texi @@ -1517,8 +1517,6 @@ Creates the tap ``foobar.tap'' with the instruction register (IR) is 7 bits long, during Capture-IR 0x42 is loaded into the IR, and bits [6,4,2,0] are checked. -FIXME: The IDCODE - this was not used in the old code, it should be? -Right? -Duane. @item @b{Optional configparams} @comment START Optional @itemize @bullet @@ -1613,13 +1611,13 @@ have the taps created in the proper order. @* @b{Removed: 28/nov/2008} This command has been removed and replaced by the ``jtag newtap'' command. The documentation remains here so that one can easily convert the old syntax to the new syntax. About the old -syntax: The old syntax is positional, ie: The 4th parameter is the +syntax: The old syntax is positional, ie: The 3rd parameter is the ``irmask''. The new syntax requires named prefixes, and supports -additional options, for example ``-irmask 4''. Please refer to the +additional options, for example ``-expected-id 0x3f0f0f0f''. Please refer to the @b{jtag newtap} command for details. @example -OLD: jtag_device 8 0x01 0x0e3 0xfe -NEW: jtag newtap CHIPNAME TAPNAME -irlen 8 -ircapture 0xe3 -irmask 0xfe +OLD: jtag_device 8 0x01 0xe3 0xfe +NEW: jtag newtap CHIPNAME TAPNAME -irlen 8 -ircapture 0x01 -irmask 0xe3 @end example @section Enable/Disable Taps @@ -2990,10 +2988,11 @@ This would cause GDB to connect to the gdbserver on the local pc using port 3333 @item A pipe connection is typically started as follows: @example -target remote openocd --pipe +target remote | openocd --pipe @end example This would cause GDB to run OpenOCD and communicate using pipes (stdin/stdout). -Using this method has the advantage of GDB starting/stopping OpenOCD for debug session. +Using this method has the advantage of GDB starting/stopping OpenOCD for the debug +session. @end enumerate @*To see a list of available OpenOCD commands type @option{monitor help} on the |